BIGFOOT GEAR HOUSING
Page 6B-56 90-857046R1 NOVEMBER 2001
10. Lubricate I.D. of cover with 2-4-C Marine Lubricant with Teflon.
11. Rotate drive shaft clockwise and push impeller housing down (over impeller) until it con-
tacts water pump base.
12. Apply Loctite 271 to bottom threads of cover screws. Install cover screws and tighten
to specified torque.
19212
b
a
95
2-4-C Marine Lubricant with Teflon
95
b
a- Impeller Housing
b- Screw (4) M6 x 30
Screw Torque
60 lb-in. (6.8 Nm)
NOTE: It is recommended that the gearcase be pressure tested for leaks after reassembly
and BEFORE gear lube is added. Gearcase should hold 10-12 psi (69-83 kPa) for 5 min-
utes.
To Next Page
Loading...
