BIGFOOT GEAR HOUSING
90-857046R1 NOVEMBER 2001 Page 6B-55
IMPORTANT: To prevent cutting the seal lips remove any burrs or sharp edges from the dri-
veshaft splines before installing water pump base assembly.
7. Install components as shown. Apply Loctite 271 on bottom half of screw threads and
tighten to specified torque (in sequence shown).
19217
a
7 Loctite “271”
1
2
3
4
5
6
b
a- Water Pump Base
b- Screw (6) M6 x 1 and Washers(6)
Screw Torque
60 lb-in. (6.8 Nm)
8. Install gasket and plate.
19219
a
b
a- Gasket
b- Plate
IMPORTANT: If the old impeller is re-used it must be installed in original (clockwise)
direction of rotation.
9. Install gasket, drive key and impeller.
19220
a
b
c
a- Gasket
b- Drive Key
c- Impeller
To Next Page
Loading...
