EasyManuals Logo

Monarch nice3000 User Manual

Monarch nice3000
322 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #227 background imageLoading...
Page #227 background image
8 Description of Function Codes NICE3000
new
User Manual
- 226 -
8
in F8-06 and F8-07. You can also manually input the data according to the actual situation.
F8-01 is used to set the pre-torque compensation mode at startup of the elevator.
The values are as follows:
0: Pre-torque invalid
Load cell auto-tuning is allowed.
1: Load cell pre-torque compensation
With a load cell, the system implements the pre-torque compensation function.
2: Automatic pre-torque compensation
The system automatically adjusts the compensated torque at startup without a load cell.
If F8-01 is set to 1, the system outputs the torque matching the load in advance to ensure the
riding comfort at startup. The output torque is limited by F2-08 (Torque upper limit). When the
load torque is greater than the set torque upper limit, the output torque of the system is the torque
upper limit.
F8-02 is used to set the pre-torque offset. It is actually the balance coefcient of the elevator,
indicating the percentage of the car load to the rated load when the counterweight and the car
weight are balanced.
F8-05 is readable and reects the load condition in the car. The value is sampled by the
NICE3000
new
by using a load cell to judge overload or full-load, or calculate the torque current for
load cell pre-torque compensation.
F8-06 and F8-07 respectively records the car no-load and full-load conditions in the car. They are
AD sampling values.
8.11.2 Pre-torque Gain
Function Code Parameter Name Setting Range Default Unit Property
F8-03
Drive gain 0.00–2.00 0.60
-
F8-04
Brake gain 0.00–2.00 0.60
-
These two parameters are used to set the pre-torque gain when the elevator runs on the drive side or the
brake side.
For details, see section 6.1.6.
8.11.3 Anti-nuisance Function
Function Code Parameter Name Setting Range Default Unit Property
F8-08
Anti-nuisance function 0, 1, 2, 4 0 -
It is the criteria for judging whether nuisance exists.
The values are as follows:
0: Anti-nuisance function disabled

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Monarch nice3000 and is the answer not in the manual?

Monarch nice3000 Specifications

General IconGeneral
BrandMonarch
Modelnice3000
CategoryController
LanguageEnglish

Related product manuals