Monarch nice3000 User Manual

NICE3000
new
User Manual 8 Description of Function Codes
- 227 -
8
●
1: Nuisance judged by load cell
A load cell is required. The system judges whether nuisance exists by comparing the load cell
data and the number of car calls.
●
2: Nuisance judged by light curtain
The system determines that nuisance exists when the light curtain does not act after the elevator
stops at arrival for three consecutive times.
●
4: Nuisance judged by light-load signal
If the light-load signal is active, the system determines that nuisance exists when the number of
car calls is greater than a certain value.
When the system determines that the elevator is in the nuisance state, it cancels all car calls. In this case,
call calls need to be registered again.
8.11.4 Hall Call Communication Parameters
Function Code Parameter Name Setting Range Default Unit Property
F8-14
HCB communication rate
Bit0: HCB communication baud rate
Bit4: Energy saving of HCB
communication
0 -
☆
F8-16
Start address of hall call
auxiliary command
0–40 0 -
★
F8-17
Hall call address check 0–1 0 -
★
●
F8-14 Bit0 = 0: The communication baud rate between the MCB and HCB is 9600 bps.
●
F8-14 Bit0 = 1, the communication baud rate between the MCB and HCB is 38400 bps.
Note that only the NICE3000
new
series products supports 38400 bps, and the NICE3000 supports only
9600 bps. The system automatically determines the communication baud rate, and generally, you need not
set this parameter.
F8-16 is used to set the HCB start address of the back door in opposite door mode.
HCB address of back door = HCB address of front door at the same oor + F8-16
If F8-17 is set to 1, the HCB no longer displays the current oor information of the car but displays the set
address of itself, convenient for inspection in the case of wrong oor address setting. This function is valid
only when the communication baud rate is 38400 bps.
8.12 Time Parameters
Function Code Parameter Name Setting Range Default Unit Property
F9-00
Idle time before returning to base oor 0–240 10 min
☆
It is used to set the idle time of the elevator before returning to the base oor.
When the idle time of the elevator exceeds the setting of this parameter, the elevator returns to the base
oor.

Monarch nice3000 Specifications

General

Brand	Monarch
Model	nice3000
Category	Controller
Language	English