Monarch nice3000 User Manual

6 System Commissioning and Functions NICE3000
new
User Manual
- 110 -
6
Chapter 6 System Commissioning and Functions
6.1 System Commissioning Guide
This chapter describes the basic commissioning guide of the NICE3000
new
. By following the instruction,
you can perform complete commissioning on the elevator system and implement all basic normal running
functions of the elevator.
Figure 6-1 Overall commissioning owchart of the NICE3000
new
Start
End
Full-load/overload commissioning
Running in attendant state
Independent running
Fire emergency running
Elevator lock
VIP function
Motor auto-tuning
Running test at inspection speed
Shaft auto-tuning
Car commissioning
HCB installation and setting
Leveling accuracy adjustment
Riding comfort adjustment
Section 6.1.1
Section 6.1.2
Section 6.1.3
Section 6.1.4
Section 6.1.5
Section 6.1.6
Safety and circuit
check
Power-on and
controller state check
Commissioning at
inspection speed
Commissioning at
normal speed
Function
commissioning
Riding comfort
adjustment
6.1.1 Safety and Circuit Check
1. System wiring diagram
Refer to Figure 3-11 in section 3.2.1.
NOTE
The input and output terminals of the NICE3000
new
has default setting at delivery. You can change
the setting based on your requirements. The examples in this manual are all based on the default
setting of the terminals.
2. Safety check owchart

Monarch nice3000 Specifications

General

Brand	Monarch
Model	nice3000
Category	Controller
Language	English