Monarch nice3000 User Manual

8 Description of Function Codes NICE3000
new
User Manual
- 248 -
8
Function Code Parameter Name Setting Range Default Unit Property
FC-26
2nd fault month and day 0–1231 0 MM.DD
●
FC-27
2nd fault hour and minute 0–23.59 0 HH.MM
●
···
FC-56
10th fault code 0–9999 0 -
●
FC-57
10th fault subcode 0–65535 0 -
●
FC-58
10th fault month and day 0–1231 0 MM.DD
●
FC-59
10th fault hour and minute 0–23.59 0 HH.MM
●
These parameters record the latest 10 faults of the elevator.
Figure 8-29 Fault code display
RUN
LOCAL/REMOT FED/REV TUNE/TC
Floor where the car
is located at fault
Fault code
For example, if FC-20 is displayed as , indicating that the 1st fault code is Err35 and the car is
near oor 8 when this fault occurs.
The fault subcode is used to locate the causes of the fault. The specic fault time is recorded in month,
day, hour and minute.
8.16.3 Latest 10 Fault Information
Function Code Parameter Name Setting Range Default Unit Property
FC-60
Latest fault code 0–9999 0 -
●
FC-61
Latest fault subcode 0–65535 0 -
●
FC-62
Latest fault month and day 0–1231 0 MM.DD
●
FC-63
Latest fault hour and minute 0–23.59 0 HH.MM
●
FC-64
Logic information of latest fault 0–65535 0 -
●
FC-65
Curve information of latest fault 0–65535 0 -
●
FC-66
Set speed upon latest fault 0.000–4.000 0 m/s
●
FC-67
Feedback speed upon latest fault 0.000–4.000 0 m/s
●
FC-68
Bus voltage upon latest fault 0.0–999.9 0 V
●
FC-69
Current position upon latest fault 0.0–300.0 0 m
●
FC-70
Output current upon latest fault 0–999.9 0 A
●
FC-71
Output frequency upon latest fault 0.00–99.99 0 Hz
●
FC-72
Torque current upon latest fault 0.0–999.9 0 A
●

Monarch nice3000 Specifications

General

Brand	Monarch
Model	nice3000
Category	Controller
Language	English