Monarch nice3000 User Manual

NICE3000
new
User Manual 8 Description of Function Codes
- 263 -
8
Bit Function Description Default
Bit0 to Bit1 Reserved - 0
Bit2 Re-leveling function
The elevator performs re-leveling at a low speed with
door open. An external shorting door lock circuit contactor
needs to be used together.
0
Bit3 Door pre-open function
During normal stop, when the elevator speed is smaller
than a certain value and the door zone signal is active, the
system shorts the door lock by means of the shorting door
lock circuit contactor and outputs the door open signal,
implementing door pre-open. This improves the elevator
use efciency.
0
Bit4 Stuck hall call cancellation
The system automatically identies the state of the hall call
buttons. If the state is abnormal, the system cancels the
stuck hall call.
0
Bit5
Night security oor
function
From 10:00 p.m to 6:00 a.m., the elevator runs to the
security oor rst every time, stops and opens the door,
and then runs to the destination oor.
0
Bit6
Down collective selective
peak service
The peak service at down collective selective is used. 0
Bit7
Parallel/Group control
peak service
The peak service is used. 0
Bit8
Time-based service oor
function
For details, see the description of related parameters in
group F6.
0
Bit9 VIP function The VIP function is used. 0
Bit10 Reserved - 0
Bit11 Car call deletion
A call can be deleted by pressing the button twice
consecutively.
1
Bit12 Hall call deletion 0
Bit13 to
Bit15
Reserved - 0
◆
FE-33 Elevator Function Selection
Function Code Parameter Name Setting Range Default Unit Property
FE-33
Elevator function selection 0–65535 36 -
☆
FE-33 is used to select the elevator functions. Each bit of the function code denes a function, as
described in the following table.
If a bit is set to 1, the function indicated by this bit is enabled; if this bit is set to 0, the function is disabled.
For details on how to view and set this function code, see the descriptions in section 8.21.1.
The functions dened by the binary bits of FE-33 are described in the following table.
Bit Function Description Default
Bit0 Reserved - 0
Bit1
Door open holding at open
limit
The system still outputs the door open command upon door
open limit.
0
Bit2
Door close command not
output upon door close
limit
The system stops outputting the door close command upon door
close limit.
1

Monarch nice3000 Specifications

General

Brand	Monarch
Model	nice3000
Category	Controller
Language	English