Morgana DocuMaster MFC - Page 7

Morgana DocuMaster MFC - Service Manual v
CONTENTS
7.7.1 Install the Software through an Ethernet Connection ........................................................237
7.7.2 Update the Software through the Ethernet Connection .....................................................238
7.7.3 Configure the Solarwinds TFTP Server.............................................................................238
7.7.4 How to find the IP Address................................................................................................239
7.7.5 Create the Ethernet Connection........................................................................................240
7.7.6 Update the MFC Software through an Ethernet Connection .............................................241
7.8 Crease Control Software Updates though a PICkit 2 Programmer ...................................... 242
7.8.1 Create the PICkit 2 Connection.........................................................................................243
7.8.2 Transfer the Creaser Control Software to the PICkit 2 Programmer ................................. 244
7.8.3 Update the Creaser Control Software ...............................................................................246
7.8.4 Update the Creaser Control Software - Replace the Processor PCB ................................ 246
7.9 GUI CPU Error Beeps ..............................................................................................................247
7.10 PC Configuration Problems ....................................................................................................248
7.10.1 Install Hyperterminal on a Vista or Windows 7 Operating System...................................248
7.10.2 Setting the Network Port Number Range (Vista and Windows 7)....................................248
SECTION 8 Installation Manual
8.1 Before Installation ...................................................................................................................252
8.2 Unpack the MFC.......................................................................................................................253
8.2.1 Unload the MFC................................................................................................................253
8.2.2 Install the Adjustable Feet.................................................................................................254
8.2.3 Remove the Transport Brackets........................................................................................ 254
8.3 Install the MFC ......................................................................................................................... 255
8.3.1 Install the CAP ..................................................................................................................255
8.3.2 Adjust the Voltage Settings ...............................................................................................255
8.3.3 Install the MFC..................................................................................................................255
8.3.4 Connect the Booklet-Maker System.................................................................................. 255
8.3.5 Turn on the Booklet-Maker System...................................................................................256
8.3.6 Turn on the MFC...............................................................................................................256
8.3.7 Make Some Book Samples ...............................................................................................257
8.3.8 Check the Book Quality ....................................................................................................257