Overview
2-18
diag [enable|identify|limit|
period]
Use this parameter as a diagnostics tool.
• enable – Enables service diagnostics.
• identify – Identifies this switch by flashing the LEDs.
• limit – Diagnostic limit command.
• buffer (128|128k|16k|1k|256|2k|32|32k|4k|512|64|64k|8k) <0-65535>
– Buffer usage warning limit.
• fan <1-3> – Fan speed limit of the fan number.
• filesys (etc2|flash|var) – File system freespace limit.
• inodes (etc2|flash|var) – File system inode limit.
• load (1|15|5) – Aggregate processor load during the previous
minutes, based on the option selected.
• maxFDs <0-32767> – Maximum number of file descriptors.
• pkbuffers <0-65535> – Packet buffer head cache.
• procRAM <0.0-100.0> – RAM % used by a process.
• ram <0.0-25.0> – Percent free RAM.
• routecache <0-65535> – IP route cache usage.
• temperature <1-8> (critical|high|low) – Temperature limit.
• period <100-30000> – Set diagnostics period. The default period is set as
1000 milliseconds.
encrypt (secret) <2> LINE
Encrypt passwords with secret phrase, using a SHA256-AES256 type of
encryption.
locator
Flash all LEDS to locate switch visually.
To Next Page
Loading...
Need help?
General
