NEC SL1000 - Page 121

Item
No.
Item Input Data Default
Related Program
Note
21 Caller ID Block Code
Enter the code, up to 8 digits,
that should be used as the Caller
ID Block Code. This code is au-
tomatically inserted before dialed
digits if Program 14-01-20 is set
to 1.
Dial (up to eight dig-
its)
No setting 14-01-20
20-08-15
22 Caller ID to Voice Mail
Enable or disable the system
ability to send the Caller ID digits
(Remote Log-On Protocol) to
voice mail.
0 = Disable (No)
1 = Enable (Yes)
0
23 Least Cost Routing 0 = LCR Off
1 = LCR On
2 = LCR On (Cost
Center Code only)
0
24 Trunk-to-Trunk Outgoing
Caller ID through Mode
Enable (1) or Disable (0) the
ability to send the original Caller
ID through when the call is For-
ward Off-Premise.
0 = Disable (No)
1 = Enable (Yes)
0
25 Continued/Discontinued
Trunk-to-Trunk Conversation
Enable (1) or Disable (0) the
ability to dial a service code to
continue or disconnect the
Trunk-to-Trunk conversation
after the alert tone is heard.
0 = Disable (No)
1 = Enable (Yes)
0 20-28-01
20-28-02
20-28-03
24-02-07
24-02-10
25-07-07
25-07-08
26 Automatic Trunk-to-Trunk
Transfer Mode
0 = Normal Transfer
(Normal)
1 = Step Transfer
(Step)
0 24-02-11
24-02-12
27 Caller ID Refuse Setup 0 = Disable (No)
1 = Enable (Yes)
0
28 Effectively of "Conversation
Recording Destination for
Extension"
0=NoEffect(No)
1 = Available (Yes)
1 15-12
30 Flexible Ringing by Caller ID 0 = Disable (No)
1 = Enable (Yes)
1 13-04
32 Anti-trombone Function 0=NoEffect(No)
1 = Available (Yes)
0
33 APSU(VM00) Trunk Receive
Gain
Additional PAD when a trunk call
connects to APSU Voice Mail.
1~63
(- 15.5 dB ~ + 15.5
dB in 0.5 dB inter-
vals)
32 (0 dB)
Default
Item01 : Trunk Name
Trunk Port Number Name
1 Line 001
2 Line 002
::
126 (SL1000)
96 (SL1100)
Line 126 (SL1000)
Line 96 (SL1100)
ISSUE 1.0 SL1000/SL1100
Program
14
Programming Manual 2-99