NEC SL1000 - Page 29

Item No. Item Input Data Default Note
06 Connection Bus Mode 0 = Extended passive bus
1 = Short passive bus
0
07 S-point DDI digits 0~4 0
08 Dial Sending Mode
ISDN Protocol definition
0 = Enblock Sending
1 = Overlap Sending
1
09 Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending
Mode (10-03-08) is set for 1
(Overlap Sending]
0 = Keypad Facility
1 = Called Party Number
1
14 Service Protocol for S-point 0 = Keypad facility
1 = Specified Protocol for Aspire system
0
15 Call Busy Mode for S-point 0 = Alerting
1 = Disconnect
0
17 ISDN Line Ringback Tone
System can provide ringback
tone, if set to 1 : Enable.
0=Disable
1=Enable
0
18 Type of Number
ISDN Protocol definition
0 = Unknown
1 = International number
2 = National number
3 = Network specific number
4 = Subscriber number
5 = Abbreviated number
0
19 Numbering Plan Identification
ISDN Protocol definition
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
0
24 Power feeding for S-point 0=Disable
1=Enable
0
For PRIU PKG Setup
ISDN Line Number 01 ~ 30
Item No. Item Input Data Default Note
01 ISDN Line Mode 0 = No setting
1 = T-Point
2 = S-Point
6 = S-Point (Leased Line)
1
02 Logical Port Number
The start port number
of a PRI line is
displayed.
[0:Nosetting]=0
[1:T-Point]=1~126(SL1000)1~96
(SL1100)
[2:S-Point]=1~128(SL1000)1~120
(SL1100)
[6 : S-Point (Leased Line)]=1~128
(SL1000) 1 ~ 120 (SL1100)
0
03 CRC Multi-frame (CRC4)
(Only for 2M = 30ch Mode)
0=off
1=on
1
04 Layer 3 Timer Type
Each timer value of
Layer 3 is set up for
each type in Program
81-06 (T-Bus)
1~5 1
ISSUE 1.0 SL1000/SL1100
Program
10
Programming Manual 2-7