NEC T30A - Page 222

-195-
AppendixC Library error code / Drive error code
Library error code (1/16)
Code(
H
)
Description
Panel
Indicator
Action
0000
No information available for this error code.
－
Nothing.
0001
Detected firmware defect during power-on
and initializing.
(FRU)
Contoller board
All LED on
To power cycle the library.
0002
Detected RAM (base area) defect during
power-on and initializing.
(FRU)
Controller board
POWER LED
and
FAULT LED
on
To power cycle the library.
0003
Detected RAM (buffer space) defect during
power-on and initializing.
(FRU)
Controller board
CHK
0003
To power cycle the library.
0004
Reserved
－
0005
Reserved
－
0006
Reserved
－
0007
Cannot detect rear magazine.
(FRU)
Magazine, Maintenance chassis
CHK
0007
1. Check rear magazine.
2. To power cycle the library.
0008
Cannot detect available drive.
(FRU)
Drive I/F cable, Drive, Controller board
CHK
0008
To power cycle the library.
0009
The accessor locking screw is not removed.
(FRU)
The Accessor locking screw
CHK
0009
Remove the accessor locking screw.
000A
Reserved
－
000B
The tape cartridge remained in the escape slot
because error detected.
CHK
000B
Check the error logs for failed
operations immediately before this
error code.
000C
Microcode failure#1
CLEAN,MEDIA
FAULT,FAULT LED
on
000D
Microcode failure#2
MEDIA
FAULT,FAULT LED
on
000E
Microcode failure#3
CLEAN,FAULT LED
on
000F
Microcode failure#4
FAULT LED on