SECTION 5
DISASSEMBLY AND ASSEMBLY
110
Non-Operator Side (NOTE: This procedure requires two people.):
1. Loosen Service Station
Motor and Motor Belt
Tensioners screws [A] and
[B]. This should release
tension on the inner Non-
Operator Side Service
Station Belts.
2. Remove the E-clip
securing the Service
Station Belt Tensioner
Pulley [C] and remove the
larger black Pulley.
3. Operator Side:
Remove (2) screws
securing the Support
Strut Bracket [D] to the
Clamshell Frame.
4. Remove Top
Assembly. Remove (4)
screws [E] securing the
Top Assembly hinges to
the Printer (2 screws per hinge).
5. Carefully lift the Top Assembly off of the Printer. DO NOT
pull or strain ink hoses or wire harnesses. NOTE: You may
have to detach the ink hoses from the hose loom, note the
order for reassembly. Put clean, dry rags on the Printer to
protect against damage and gently rest the Top Assembly back
on the Printer.
6. Carefully lift the Top Assembly so you can access and remove (1)
screw securing the Service Station Slide [F] to the Service Station
Sled. (Access through the Printhead opening in the underside of
the Top Assembly.)
Try to keep the Assembly level to prevent any ink spills. You may
have to have another person hold the Top Assembly to do this.
To Next Page
Loading...
Need help?
General
