SECTION 3
TOUCHSCREEN AND TOOLBOX OPERATION
27
Date and Time – Enter or change the way the date and time will appear in the Printer Status section of the Toolbox
screens. To enter or change Date and Time:
1. From the Toolbox, select “View” drop-down menu, click
“Service Menus”, then click “System Settings”.
2. “System Settings” page opens. Use Date and Time options to
enter, edit and format the Date and Time for the Printer.
3. Click “Submit”.
Debug Level – Set the detail level of the Debug Logs. To change the Debug Level:
1. From the Toolbox, select “View” drop-down menu, click
“Service Menus”, and then click “System Settings”.
2. “System Settings” page opens. Go to Debug Level options
and select 0, 1, or 2 to set the desired level for the Printer.
(0 = least detailed, 2 = most detailed). NOTE: Because of
the amount of data collected and stored, it is recommended
that you not set the Debug Level over 1 unless asked by a
service technician.
3. Click “Submit”.
To Next Page
Loading...
Need help?
General
