Oki IP-6620 - Page 253

253
Troubleshooting
[Symptom B]
Print head nozzles inclination
(1) Print a nozzle print pattern, and set nozzle map for the inclined nozzles. (
page
105)
(2) Printing with a color stripe bar is effective to prevent missing dots. (
page 174)
[Symptom C]
The ink does not match the media.
(Media with low dot spread rate)
(1) Decrease the temperature of all three heaters by 5°C. *
1
* Before starting the print, ensure that the heater temperatures have been decreased to
the target temperature.
* With some media, the increasing the heater temperatures may be eective.
(2) Change the print mode to be slower. *
1
*
2
(3) Use proven media.
(4) Print in high density.
*1 Adjust the media advance adjustment value again.
*2 Note that the print speed diers depending on the mode selected.
Before printing Loading the media Adjustment Maintenance
Advanced
operations
Troubleshooting
Menu tree Appendix