Technical Reference Guide – Appendix D – Media specifications > 231
of about 3 mm between parts. Stapling with metal staples is
strictly prohibited.
Spot gluing
> Forms are to be spot glued at both sides (single-side spot
gluing is not allowed).
> Each glue application spot must be glued evenly, and be of
3 to 5 mm in size. The glue spot is to be accurately
pressed to prevent its floating and there is to be no
significant creasing.
> For positioning of glue spots, see the illustration below.
> Spot gluing is to be applied in a staggered format.
Gluing the lines
> The glue line area should be even, with a width of 1 –
2 mm.
> Always press the glue line area to prevent any lifting.
Further, do not use any paper which has significant
wrinkling.
> Ensure that the glue does not extend outside the margins
of the paper.
Glue spot
)sehcni2( mm8.05
trap ts1
trap dn2
t
r
a
p
dr3
t
ra
p
h
t
4
t
ra
p
h
t
5
To Next Page
Loading...
