Technical Reference Guide – Appendix D – Media specifications > 232
> Be careful if the glue area is on thick (hard) paper, since
this can affect paper feed precision.
Paper stapling
> Stapling of both sides of the paper is allowed. Stapling on
only one side is not allowed.
> The paper must always be stapled from the front of the
paper. Ensure that the staple does not emerge from the
front page.
> The paper must be stapled with double staples in the
paper feed direction. It is also recommended that that the
staples are applied in order in the paper feed direction.
> Make sure that the paper is securely stapled without any
lifting being evident.
> After the paper is stapled, it should be pressed to prevent
any lifting.
1~2mm
Glue area
trap ts1
trap dn2
t
r
ap dr3
trap ht4
trap ht5
To Next Page
Loading...
