Technical Reference Guide – Appendix D – Media specifications > 247
around a 27 mm-diameter core, adhesion must be such
that the labels do not peel off the substrate.
The adhesive strength is given as a guideline. It is essential
that label paper is kept in a condition which does not allow
labels to peel during printing or paper feeding.
> Waste Removal
Waste facestock around labels is not to be removed. Label
paper from which waste is removed as illustrated below is
not to be used as it results in surface level differences.
Label corners must be rounded (R4 to R5 mm).
> Cuts
Label cuts are to be made only in the facestock.
Label cuts corresponding to substrate horizontal
perforations are to coincide with those perforations, with
an uncut within 1 to 2 mm of each side.
F
Substrate
Facestock
Width 1 inch (25.4 mm)
Peel strength 10g/inch
Label
Level difference caused
Label
Substrate
Waste removed
To Next Page
Loading...
Need help?
General
Weight and Dimensions
