Technical Reference Guide – Operator interface > 61
Set-up menu Paper End Select whether a
printer status where
no paper is loaded is
set to SEL or DESEL.
On-line
Off-line
Print
Direction
Command
Select the validity of a
one-way print setup
command.
Valid
Invalid
Print Speed
Command
Select the validity of a
print speed setup
command.
Valid
Invalid
LF Pitch
Command
Select the validity of a
linefeed pitch
command.
Valid
Invalid
Font
Command
Select the validity of a
font command.
Valid
Invalid
Pitch
Command
Select the validity of a
character pitch
command.
Valid
Invalid
Parallel I/F I-Prime Set I-Prime signal
control or the
Centronics interface.
Invalid
Buffer Print
Buffer Clear
Auto Feed
XT
Set whether to enable
or disable Auto Feed
XT signal of the
Centronics interface.
(EPSON emulation
only)
Valid
Invalid
Bi-Direction Set whether to enable
or disable Two-way
communication of the
Centronics interface.
Enable
Disable
Serial I/F Parity Set parity. None
Odd
Even
Ignore
Serial Data
7/8 Bits
Set serial data length. 8 bit
7 bit
Protocol Set Protocols. DTR
X-ON/X-OFF
DTR & X-ON/X-OFF
MENU ITEM FUNCTION SETTING
To Next Page
Loading...
