Technical Reference Guide – Operator interface > 62
ML1190 eco
In the menu settings tables below, factory default settings are
shown in bold.
Serial I/F Diagnostic
Test
Set/Cancel loop
testing of the serial
interface.
No
Yes
Baud Rate Set the transmission
speed of the serial
interface.
9,600 bps
4,800 bps
2,400 bps
1,200 bps
600 bps
300 bps
19,200 bps
DTR Signal Set whether to switch
the DTR signal of the
serial interface by
Select/Deselect or
hold it after power-
on.
Ready on Power UP
Ready on Select
Busy Time Set the minimum
time it takes to switch
from a busy state to a
ready state.
0.2 sec
1.0 sec
MENU ITEM FUNCTION SETTING
MENU ITEM FUNCTION SETTING
Printer
Control Menu
Emulation
mode
Select EPSON LQ
mode, IBM PPR
mode, or IBM
AGM mode.
EPSON
IBM PPR
IBM AGM
Font menu Print Mode Select quality of
ANK characters.
LQ Courier
LQ Roman
LQ Swiss
LQ Swiss Bold
LQ Orator
LQ Gothic
LQ Prestige
LQ OCR-A
LQ OCR-B
Utility
HSD
To Next Page
Loading...
