APPLIED OPERATIONS/Image Acquisition
OPERATION INSTRUCTIONS
2-82
Page
2-2-8-1 Virtual Channel Function
The virtual channels refer to the simulated detection channels produced when a single
detector switched in sequential scan. The virtual channels make it possible to perform
sequential scan by switching the lasers and filters according to the preset condition by
increasing the number of detection channels.
Up to 6 virtual channels can be set up.
If 6 channels are already used by means of option units, it is no longer
possible to set up a virtual channel.
Operation Example
The following procedure deals with the case of observing FITC in CH1, PI in CH2 and Cy5 in
a virtual channel.
1. In the [Dyes] sub-panel of the [Acquire] panel, select the dyeing methods and click the
<Apply> button. (Example: FITC and PI are selected.)
For details, see step 2 in the procedure in section 2-2-1-1, “Configuring the
Microscope”.
2. Click the <Once> button to acquire an image.
<Once> button
NOTE
To Next Page
Loading...
Need help?
General
