Appendix E List of Functions in the [Active Overlays] Dialog Box/Coordinate Position Data
OPERATION INSTRUCTIONS
E-1
Page
Appendix E List of Functions in the
[Active Overlays] Dialog Box
Active Overlays is a kind of overlay function displayed on an image.
Active Overlays does not simply show the entered characters, but searches the image data
related to the keyword specified in < > and displays the data values on the image.
The following setups are required to enable the use of Active Overlays.
Appendix E-1 Coordinate Position Data
Appendix E-1-1 X-Coordinate
The X-coordinate position with respect to the top left corner of the screen is displayed.
«Syntax»
<x[ [hotspot] [raw/calibrated] value [units]]>
Arguments inside [ ] can be omitted.
If [raw/calibrated] is omitted, the same setting as when [calibrated] is specified will be
applied.
«Setup Procedure»
1. Enter “x” as the first character inside < >.
2. Add the following characters to set the display method.
hotspot : Display measurement points with “+” markings.
raw : Display data in pixel values.
calibrated : Display data in numerical values (µm).
units : Display the unit (pixels/µm).
«Examples»
<Input character strings> <Displayed strings (** represent figures.)>
<x raw value>…………………………………**
<x hotspot raw value>……………………….+**
<x hotspot calibrated value units>…………+**µm
The detailed display procedure is described in section 2-11-3, “Viewing the X- or
Y-Coordinate Position of Image” in Volume [OPERATION].
TIP
To Next Page
Loading...
