Olympus Fluoview FV1000 - Examples of Operation Procedures

APPLIED OPERATIONS/General Operation Procedure
OPERATION INSTRUCTIONS
2-5
Page
2-1-3 Examples of Operation Procedures
Begin using the FLUOVIEW system by acquiring an image or opening an image in a file.
For the detailed operation method of each item in the procedure, see the section
specified in parentheses (( )).
Example 1) To perform XYZ observation of a cell,
apply filter processing to the image,
display animation to identify the cell shape,
then calculate the area, and save the
obtained image data:
Example 2) To open a previously acquired image in a
file, measure the intensity distribution and
edit data with Excel:
Specify the area to be measured
Measure the intensity distribution.
(Section 2-7-2)
Exit from the FLUOVIEW software
and turn power OFF.
(Sections 1-2-10)
Save the measurement data in
the Excel format.
(Section 2-11-1)
Turn power ON and start the
FLUOVIEW software.
(Sections 1-2-1)
Open an image in a file.
(Section 2-3-2)
Acquire an image.
(Section 2-2)
Turn power ON and start the
FLUOVIEW software.
(Sections 1-2-1)
Apply filter processing.
(Section 2-6-1)
Display the animation.
(Section 2-9-2)
Measure area
(Section 2-7-3-2)
Exit from the FLUOVIEW software
and turn power OFF.
(Sections 1-2-10)
Save the image.
(Section 2-3-1)
Read the saved measurement data
with Excel and edit it.
When
there is
another
area to be
measured