Olympus Fluoview FV1000 - Building Line Images to be Viewed in Z Direction

APPLIED OPERATIONS/Building an Image from a Different Viewpoint
OPERATION INSTRUCTIONS
2-301
Page
2-8-2 Building line images to be viewed in Z direction
The images acquired by cutting the XYZ image off vertically and horizontally can be
displayed with the information on each line.
Each line images is created as a separate image from the original one.
1. Display the image window of the XYZ (multiple sections) image.
2. Click the < New Multi-Plane Form > button in the toolbar.
The [3D-] panel is created to start the line image building.
Fig. 2-122 Panel showing the line images to be viewed in Z direction
< New Multi-Plane Form >
button
Image display in XY-direction
The line image to be displayed
in XZ or YZ-direction can be
moved by dragging the red line
(XZ) or brown line (YZ) on the
XY-direction image.
Line image display in XZ-
direction
Display the image of the line
specified on the XY-direction
ima
g
e.
Line image display in YZ-direction
Display the image of the line
specified on the XY-direction image.
Upper row : shows the current slice and the steps in Z-direction acquiring the
image.
[z=] : the number of current steps
[Slice] :the number of current slice
Lower row: shows the current X and Y coordinates and Z position on the XY-
direction image.
[X:] : current X position
[Y:] : current Y position
[Z:] : current Z position