Olympus Fluoview FV1000 - Merger;Extraction of Image Channels; Setting the Range of Multiple Image Slices

APPLIED OPERATIONS/Merger/Extraction of Image Channels
OPERATION INSTRUCTIONS
2-338
Page
2-14 Merger/Extraction of Image Channels
2-14-1 Setting the Range of Multiple Image Slices
When merging or extracting channels in images composed of multiple image slices, such as
time-lapse images and images acquired by varying the cross-sections, it is possible to select
only some of image slices as the target of channel merger or extraction. This section
describes how to set the range of target image slices.
1. Display the image window of the images composed of multiple image slices.
2. The buttons as shown below are displayed at the top of the image window. To switch to
the image slice of another cross-section, click the <Z/T series switch> button then click
the <XYZ series> button in the displayed list of buttons. To switch to the image slice of
another instant in the elapsed time, click the <Z/T series switch> button then click the
<XYT series> button in the displayed list of buttons. (In these operations, the icon in the
<Z/T series switch> button changes to the icon of the selected button.)
⋅• • •
<XYZ series> button
Displays one of multiple images by selecting
it according to the multiple sections (Z).
<Set start position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
start. (“0” is set when this button is not used.)
<Display> button
Press to start display of n-slices of image from the start position to the end position
sequentially (successive display) or one by one (frame-by-frame display) or to stop
successive display.
Holding the button displays image slices in successive display and clicking it displays
image slices by advancing frame by frame
<Display> button
Press to start display of n-slices of image from the end position to the start position sequentially (successive
display) or one by one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image slices by
advancing frame by frame.
<Bound> button
Every time successive display or frame-by-frame display in a direction ends
at the start or end position, the display is restarted in the opposite direction.
<Set end position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
end. (Assuming that the number of images is n, “n-1” is
set when this button is not used.)
<Z/T series switch> button
<XYT series> button
Displays one of multiple images by selecting
it according to the time (T).
<Loop> button
Successive display or frame-by-frame display is
repeated in the same direction.
<Loop/Bound switch>button
<Display speed switch> button
Set the speed of successive display.
<Rabbit> button
Press for successive display of image slices without pause.
<Turtle> button
Press for successive display of image slices at an interval of 0.8 sec