Olympus Fluoview FV1000 - Animation; Appendix E-1-3 Other; Position

Appendix E List of Functions in the [Active Overlays] Dialog Box/Coordinate Position Data
OPERATION INSTRUCTIONS
E-3
Page
Appendix E-1-3 Other
Positions can also be displayed by entering the following keywords in the syntax in place of
the X- and Y-coordinate positions described in sections J-1-1 and J-1-2.
1 Z Position
With cross-section related images such as XYZ images, the Z position with respect to the first
image can be displayed.
«Syntax»
<z[ [raw/calibrated] value [units]]>
Arguments inside [ ] can be omitted.
If [raw/calibrated] is omitted, the same setting as when [calibrated] is specified will be
applied.
2 T Position
With time-related images such as XYZ images, the T position with respect to the first image
can be displayed.
«Syntax»
<t[ [raw/calibrated] value [units]]>
Arguments inside [ ] can be omitted.
If [raw/calibrated] is omitted, the same setting as when [calibrated] is specified will be
applied.
3 Animation
With animation images created in the [Visualize] panel, the position with respect to the first
image can be displayed.
«Syntax»
<Animation[ [raw/calibrated] value [units]]>
Arguments inside [ ] can be omitted.
If [raw/calibrated] is omitted, the same setting as when [calibrated] is specified will be
applied.