Olympus Fluoview FV1000 - Setting the C.A. Diameters

Getting Started FLUOVIEW/Online Help
OPERATION INSTRUCTIONS
1-59
Page
1-3-2-5 Setting the C.A. Diameters
The pinhole diameters are set automatically according to the selected dyeing method.
Use the following procedure to change the pinhole diameters.
1. Display the [Acquire] panel.
[Ch] group box
Sets whether the image o
f
each channel is to be
acquired or not, the PMT
voltage, Gain and Offset.
Right-clicking the mouse
inside this group box
displays the [Ch] group
boxes of all channels.