APPLIED OPERATIONS/Merger/Extraction of Image Channels
OPERATION INSTRUCTIONS
2-344
Page
2-14-3 Extracting Channels from Image
Desired channels can be extracted from an image. Use this facility to extract only the images
of required channels from an image acquired from more than one channel.
1. Open the image file of the image to extract channels in advance.
When the image has been saved in more than one image file, it is possible to
use only some of the slices by setting a slice range. See section 2-14-1,
“Setting the Range of Multiple Image Slices” for the operation procedure.
The channel extraction cannot change the image type (XYZ, XYT, etc.).
Therefore, it is not possible, for example, to extract an XY image from an
XYZ or XYT image.
2. Display the [Experiment Editor] sub-panel in the [Process] panel.
Fig. 2-149 [Experiment Editor] Sub-panel
TIP
NOTE
To Next Page
Loading...
