APPLIED OPERATIONS/Image Acquisition
OPERATION INSTRUCTIONS
2-88
Page
2-2-9 Image Acquisition of a Line at Desired Angle
When the sample is not standing upright, the image of a line can be acquired by changing
the angle.
1. Acquire an image in the XY observation mode. For the operation procedure, see
section 2-2-1, “Image Acquisition with XY Observation”.
2. Select any one of <Normal>, <Clip> or <ZoomIn> of [Line XT] option button or [Depth
XZ] option button in [Mode] group box of [Acquire] panel.
A line indicating the control range appears in the [Live] panel.
3. Move the line to the area to be observed. To move the line, place the mouse pointer on
it and drag the mouse.
4. Change the line length and the inclination. Place the mouse pointer on the line and click
to display square handles on the two extremities of the line. Then place the mouse
pointer on either handle and drag it to change the line length and the inclination.
5. Acquire the image with the buttons such as the <XYZ>, <XYT>, <XYZT> buttons.
6. After acquiring the image, select <Normal> under the [Surface XY] option button in the
[Mode] group box in the [Acquire] panel to return from the image acquisition mode.
Handle
To Next Page
Loading...
Need help?
General
