APPLIED OPERATIONS/Viewing 3D Image
OPERATION INSTRUCTIONS
2-312
Page
2-9-3 Building Stereo 3D Images
Images composed of multiple image slices acquired by varying the multiple sections (XYZ
observation) can be built into a pair of stereo 3D images. These images can be viewed
three-dimensionally by watching them with two eyes for a while.
The operation is similar with animation. Perform steps 1 to 10 in section 2-9-2, “Animation”,
then proceed to the following steps. (Except that, in the [Method] group box, it is required to
click the [Brightest] option button.)
1. Check the [Stereo Pair] check box.
2. Click the <Begin Visualize> button to start building the images. When the building
completes, the built images are displayed in the [3D Animation] panel.
The status bar shows the progress of building processing.
During the building, the <Begin Visualize> button turns into the <Cancel
Visualize> button. Click the <Cancel Visualize> button if you want to cancel the
building.
3. The following buttons are displayed at the top of the image window.
4. Watch the two images with two eyes for a while. They will look as a single 3D image.
<Cancel Visualize>
button
TIP
TIP
Stereo 3D images.
To Next Page
Loading...
