APPLIED OPERATIONS/Image Analysis
OPERATION INSTRUCTIONS
2-278
Page
2-7-1-2 Intensity Values on a Planar Region (Bird’s Eye View)
The intensity values on a region in an image can be displayed graphically.
1. Display the [Single] sub-panel at the front.
2. Display the image window of the image to be subjected to the intensity checking at the
front.
3. When the image was acquired in the multi-channel mode, select whether the multiple
channels are analyzed simultaneously or only one channel is analyzed.
To select the target channel(s), use the <Display channel switch> buttons. Only the
channel(s) being displayed will be analyzed.
Example) When only the Ch1 image is displayed, only the Ch1 image is analyzed.
For the switching of channels, see section 2-5-3, “Switching the
Display Channels”.
4.
Click the <Annotate> button in the toolbar. A list of buttons appear as shown below.
5. From the displayed buttons, click the <Rectangular> button, <Circle> button or
<Polyregion> button.
<Display channel switch>
button
<Annotate> button
TIP
To Next Page
Loading...
