Olympus Fluoview FV1000 - Overall Setting of FLUOVIEW; Setting the System Configuration

Software Setup/Setting the System Configuration
MAINTENANCE
1-5
Page
1-3 Setting the System Configuration
If it is required to change the settings after having set up the software, perform the following
procedure.
Don’t double click the [FLUOVIEW Setup] icon on the desktop and boot it
up to change the system setting while the FLUOVIEW software is running.
You can change the practicable setting by selecting [Tools] > [User
Preference].
1-3-1 Overall Setting of FLUOVIEW
1. Double-click the [FLUOVIEW Setup] on the desktop.
The [FLUOVIEW User Login] dialog box appears as shown below.
2. Enter the user name in the [User Name : ] text box and click the <OK> button to log into
FLUOVIEW FV1000.
Refer to Appendix H-2 “Logging into the FV1000” for details.
[FLUOVIEW Setup] icon
NOTE