Olympus Fluoview FV1000 - Starting the Protocol Processor

APPLIED OPERATIONS/Protocol processor
OPERATION INSTRUCTIONS
2-151
Page
2-4-1 Starting the Protocol Processor
1. Starts the Protocol Processor by clicking <PAPP> button in [Time Series] sub-panel of
[Acquire] panel.
The [Programmable Acquisition Protocol Processor] window appears as shown below.
(It is referred to as the [PAPP] window in this manual.)
[PAPP] window appears where is the last time in use.
: <Start> button : Starts the protocol.
:<Break> button :Temporally stops the protocol, it can re-start by pressing <Start>
button.
:<Skip> button :Skips to the next Track of the protocol.
:<End> button :Stops the protocol.
:<Get Init Values> button: Sets [Acquire] panel parameter to the default
value.
[Init Val] box
Shows the default values
of each parameters.
<PAPP> button
Starts the Protocol Processor.