APPLIED OPERATIONS/Changing the Image Display Method
OPERATION INSTRUCTIONS
2-198
Page
2-5 Changing the Image Display Method
The method of displaying an image acquired by observation or opened from a file can be
changed as described below.
2-5-1 Displaying an Image in Simulated Colors
1. Display the image window of the image to be colored at the front.
2. Click the <LUT> button in the toolbar. The [Color Tool] dialog box appears.
Fig. 2-64 [Color Tool] Dialog Box
3. When the image was acquired from more than one channel, select the channels to be
colored using the option buttons among [Ch1] to [Ch6]. (The option buttons among
[Ch1] to [Ch6] are displayed only when an image acquired from more than one channel
mode is displayed (selected).
4. From the [Standard Color LUTs] group box, select the desired color button. The
selected LUT will be applied immediately to the image in the image window.
5. Click the <OK> button.
The [Apply to all view] check box can be selected while the image window
showing multiple images created in the [Title] panel is displayed.
When this check box is checked, all changes are applied to all of the images
shown in the image window.
<LUT> button
TIP
To Next Page
Loading...
