Olympus Fluoview FV1000 - Page 386

APPLIED OPERATIONS/Building an Image from a Different Viewpoint
OPERATION INSTRUCTIONS
2-302
Page
If you change the slice to be displayed with the <Display> button, [Slice] and [Z:]
aren’t effected.
[Slice] and [Z:] show current slice and Z position according to moving the red or
brown line indicating XZ or YZ-direction on the XY-direction image displayed left
above.
Image in XZ or YZ on 3D image built can be cut out and displayed.
1. Click any part inside the image that appears in XZ or YZ direction on [3D] panel.
Even if inside part of the image that appears in XY direction on [3D] panel is
clicked, <Accept this view as new experiment> will not be turned valid. The
part inside the image in XZ or YZ direction must be clicked.
<Display> button
TIP
Click inside part of this place in case that
the image in YZ is cut out and displayed.
Click inside part of this place in case that
the image in XZ is cutout and displayed.
TIP