Olympus Fluoview FV1000 - Page 239

APPLIED OPERATIONS/Protocol processor
OPERATION INSTRUCTIONS
2-155
Page
Normal : Starts image acquisition when protocol comes the Track.
Trigger : Starts image acquisition after receiving external trigger input.
Wait : Starts image acquisition after wait time describes the track, the unit is
second.
Condition: See the following table in case that [New mode] or [Series mode] is selected in
[Mode].
When “Command” is selected in column [Mode], the macro command can be
enter to the track. For the macro commands detail, see section 2-4-2-2,
“Command List”.
When “For” is selected in column [Mode], enter the repetition condition using a
variable. For the description of the repetition processing, see section 2-4-2-3 ,
“Protocol Repetition Processing”.
Condition column of New Mode
Sub-menu of
New mode
Change Input details
Condition column of the following
Series Mode
XY
X
Set 1 automatically
XYT
O
Set number of images to
be acquired
Enter number of slices to acquire
XYZ
X
Set 1 automatically
XYZT
O
Set number of images to
be acquired
Enter number of slices to acquire
XT
O
Set number of lines
XZ
X
Set 1 automatically
XZT
O
Set number of lines Enter number of lines to acquire
Pt*T
X
Set 1 automatically
Interval: When “Frame” is selected in column [Mode], time required to execute the track is
displayed. Change of [Interval] column cannot be done in case of [Series mode].
Frame Interval: Enter the interval time between image acquisitions in number of seconds. A
number between 0.1 and 60000.0 can be entered.
Image Size: Select acquisition image pixels. Select either [256 by 256], [320 by 240[,
[512 by 512], [640 by 640], [800 by 600], [1024 by 768], [1024 by 1024] or
[2048 by 2048] at [X-size by Y-size] list box.
Zoom: Enter the zoom ratio in the range between 1.0 and 10.0.