APPLIED OPERATIONS/ Protocol processor
OPERATION INSTRUCTIONS
2-168
Page
One Point!
It is possible to select [Set Init Val] and [Get FV Status] from [Edit] menu.
When [Select All] is selected from [Edit] menu, checks will enter all check boxes of group
boxes.
When [Invert Selection] is selected from [Edit] menu, state of checks in all check boxes of
group boxes will be inverted. When check is entered, the check will be removed and, when
check is removed, the check is entered.
It is possible to select [Set to FV] from [Action] menu.
• <Get FV Status> button loads parameters which FLUOVIEW software
has.
• By pressing
<Set> button, [Track] window setting is registered to [PAPP]
window.
•
<Cancel> button is for close [Track] window.
Parameter changes in [Track] does not affect to FLUOVIEW software
setting.
[Track] parameter can not modify nor register during the Track is running.
NOTE
NOTE
To Next Page
Loading...
