APPLIED OPERATIONS/Changing the Image Display Method
OPERATION INSTRUCTIONS
2-211
Page
2. To switch the image to the image of another multiple sections, click the <Z/T series
switch> button then, from the displayed list of buttons, click the <XYZ series> button.
To switch the image to the image of another moment in the elapsed time, click the <Z/T
series switch> button then, from the displayed list of buttons, click the <XYT series>
button. (The icon in the <Z/T series switch> button will change to the icon of the
selected button.)
3. Display the image to be displayed at the front by using the <Display> buttons at the top
of the image window.
Click and hold the <Display> button for successive display. To stop it, click the
<Display> button again.
For frame-by-frame display, simply click the <Display> button.
⋅• • •
TIP
<XYZ series> button
Displays one of multiple images by selecting
it according to the multiple sections (Z).
<Set start position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
start. (“0” is set when this button is not used.)
<Display>button
Press to start display of n-slices of image from the start position to the end position
sequentially (successive display) or one by one (frame-by-frame display) or to stop
successive display.
Holding the button displays image slices in successive display and clicking it displays
image slices by advancing frame by frame
<Display>button
Press to start display of n-slices of image from the end position to the start position sequentially
(successive display) or one by one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image slices by
advancing frame by frame.
<Bound> button
Every time successive display or frame-by-frame display in a direction ends
at the start or end position, the display is restarted in the opposite direction.
<Set end position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
end. (Assuming that the number of images is n, “n-1” is
set when this button is not used.)
<Z/T series switch> button
<XYT series> button
Displays one of multiple images by selecting
it according to the time (T).
<Loop> button
Successive display or frame-by-frame display is repeated
in the same direction.
<Loop/Bound switch>button
<Display speed switch>button
Set the speed of successive display.
<Rabbit>button
Press for successive display of image slices without pause.
<Turtle>button
Press for successive display of image slices at an interval of 0.8 sec
To Next Page
Loading...
