APPLIED OPERATIONS/Image Processing
OPERATION INSTRUCTIONS
2-235
Page
4. When the image was acquired in the multi-channel mode, select whether the LUT
intensity mapping (re-assignment) is applied to multiple channels simultaneously or to a
single channel.
To select the target channel(s), use the <Display channel switch> buttons. The histogram
of the selected channel(s) is displayed.
Example) When only the Ch1 image is displayed, the histogram of Ch1 is displayed and
mapping of only the Ch1 image is possible.
For the switching of channels, see section 2-4-3, “Switching the Display
Channels”.
5. Click the <Compute Histogram> button. A histogram appears as shown below.
Fig. 2-88 Histogram
<Display channel switch>
buttons
TIP
To Next Page
Loading...
