Getting Started FLUOVIEW/Online Help
OPERATION INSTRUCTIONS
1-43
Page
z Clicking the <Link Setting> button displays the [Link Setting] dialog box as shown
below.
Click the desired check box to be checked.
Select the <Close> button to close the dialog box.
The microscope settings are automatically saved and read out when the software is
started up next time.
Checking here links the objective in the [Nosepiece] group box
with the condenser turret.
Checking here escapes the stage or revolving nosepiece when
the objective is selected and changed in the [Nosepiece] group
Checking here disengages the top lens from the light path
when the objective of ×4 or lower magnification is selected in
the [Nosepiece] group box. (BX only)
Checking here closes the shutter when the Mirror Units are
switched in the [Mirror Unit].
Checking here sets the TD lamp to OFF when the fluorescent
cube is selected in the [Mirror Unit].
Checking here disengages the top lens from the light path
when the fluorescent cube is selected in the [Mirror Unit]. (BX
only)
Checking here enables parfocality correction when the
objective is selected and changed in the [NosePiece] group
box.
<Import Setting> button
Loads the microscope
settings already
registered to reflect it.
<Export
Setting>button
Saves the current
Checking here closes the FL shutter and engages Analyzer and
Polarizer into the light path when the TD lamp is set to ON in
the
Lam
rou
box.
When objective is selected in [Nosepiece] group box while this
box is checked, close shutter of incident lighting lamp first and
then, change objective lens. After change, open the shutter.
To Next Page
Loading...
