Olympus Fluoview FV1000 - Page 79

Getting Started FLUOVIEW/Online Help
OPERATION INSTRUCTIONS
1-57
Page
The parameters of the spectral detecting system can also be set in the [Optical System
Configuration] window as well as in the [Spectral-Control] sub panel.
1. Select the [Settings] sub panel.
Fig. 1-19 [Settings] sub panel
2. Click the <Scan Unit> button on the bottom of the [Settings] sub-panel. When the
window shown below is displayed, set up the spectral detecting system in the [SPD]
group box.
Fig. 1-20 [Optical System Configuration] window
<Scan Unit> button
Display the filter and laser
types to be set.
(Combination with the laser
combiner sets up the laser
automatically.)
Set the upper limit (left)
and lower limit (right)
wavelengths of the barrie
r
filter.
Move the upper limit o
r
lower limit wavelength
while maintaining the
width between the uppe
r
limit and lower limit
wavelengths.