APPLIED OPERATIONS/Image Acquisition
OPERATION INSTRUCTIONS
2-10
Page
2. Setting the dyeing method
1) From the page tabs on the bottom right of the [Acquire] panel, select the [Dyes]
sub-panel.
Fig. 2-2 [Dyes] Sub-panel
2) Select the specimen dyeing method by dragging desired dye names in the
[Available Dyes] list box in the [Selected Dyes] group box to the field immediately
above the list box.
Fig. 2-3 [Dyes] Sub-panel
[Available Dyes] list box
Lists the available dyes. Select
the desired items from this list
and drag them to the field above
it to select the dyeing method.
<Clear> button
Clear the set dyeing method.
<Prev.> button
Sets the dyeing method which
was set last time by clicking the
<Apply> button.
<Apply> button
pplies the dyeing method
dragged in the [Selected
Dyes] group box to the
[Ch] group in the [Acquire]
panel.
Place the pointer on the icon
displayed in the [Selected
Dyes], and the dyeing method
is shown in the pop-up display.
[Assign dyes manually]
check box
Checking this enables the
manual setting. Dragging
the dyeing method in the
list directly to the [Ch]
group box assigns the dye
to the desired channel.
To Next Page
Loading...
