APPLIED OPERATIONS/Image Acquisition
OPERATION INSTRUCTIONS
2-14
Page
4. Select the <Scope > button at the bottom of the panel. The window as shown below will
appear (in case of a combination with the IX81).
Fig. 2-5 [Microscope Control Panel] Window
5. Configure the microscope in [Microscope Control Panel] window.
6. After completing the setup, click the <Close> button to close the window.
For details of [Microscope Control Panel] window, see section 1-3-2-1
“Configuring the Microscope” in this volume.
7. While looking into the microscope, move the stage and check the observed image.
TIP
To Next Page
Loading...
