NOTE: Biometry and Topography are optional software modules. If you do not have this feature and want to
purchase it, contact Optopol’s local distributor.
Topography module provides the analysis of both surfaces based on Corneal Curvature,
Dioptric power, Elevation and Real power analysis based on both surfaces and local cornea
thickness (Ray tracing).
Topography scan program is available in Anterior scan list. It has fixed scan parameters: 16 B
scans, 8 mm width. Scan time: 0.17 sec. (0.3 for REVO 60).
Topography - Safety Notes
- NOTE: Allow only well-trained operators to use the topography module
NOTE: Layers recognition is used for tracing.
NOTE: Fully examine the measured data for layer recognition results. In particular,
if the difference between the measurement values for the left and right eye is
significant or any problem is found in the anterior chamber during the preliminary
examination, check the tracing and/or reliability on the check screen. If the
measurement result is not conclusive, review the inspection result by performing
another measurement or inspection.
NOTE: When using data taken by this instrument for diagnosis or determination of
treatment, proceed carefully by taking measurements multiple times and/or
conducting other examinations.
NOTE: When using the data taken by this instrument to select intraocular lenses,
thoroughly determine the selection by also examining cataract surgery methods
and other inspections. If incorrect measurement data is used to select intraocular
lenses, further surgery might be required.
NOTE: When using the data taken by this instrument for refractive correction
surgery, thoroughly determine the selection by also examining surgery methods
and other inspections. Refractive correction surgery conducted according to
incorrect measurements or analysis results may result in further surgery or severe
complication such as keratectasia.
To Next Page
Loading...
