29 / 374
SOCT User Manual Version 10.0 rev. A
NOTE: In situation when the cameras housing cover is removed, while examining
the patient, the system operator must not touch at the same time the patient and
uncovered parts of the device.
SOCT is connected to PC using USB 3.0 cable.
There are no user serviceable parts inside SOCT device. Light source is included inside the
device. Removing the covers can be done only by authorized personnel.
The maximum power of light radiation available outside the covers is less than 1650
microwatts providing safe operation of the device.
Objective lens is the output of light.
SOCT has been classified as a CLASS 1 laser device.
IMPORTANT:
1. If the whole Medical System has been installed by Manufacturer of SOCT or
Authorized Personnel, the manufacturer guarantees correct installation and
compliance with all required standards and directives.
2. In case installation was made not by Manufacturer or Authorized Personnel,
the manufacturer of SOCT takes no responsibility for any problems or risks that
could be created by incorrect connection and violation of safety standards.
3. Understanding and following up of chapters 5 SOCT SOFTWARE, 6 PATIENT
WINDOW, 7 EXAMINATION WINDOW, 8 CONDUCTING EXAMINATION and 9
RESULT REVIEW of this manual as well as PC experience are sufficient for
operating the SOCT device.
4. Manufacturer of SOCT takes no responsibility for incorrect medical diagnosis of
results and takes no responsibility for the consequences of such incorrect
medical diagnosis.
To Next Page
Loading...
