Panasonic fp2/fp2sh User Manual

11-44
FP2/FP2SH/FP10SH/FP3 (A: Available, N/A: Not available)
Address
Name Descriptions
Read-
ing
Writ-
ing
FP3
FP2/
FP2SH
FP10SH
DT9170 DT90170
MEWNET-
W/-P link
status
[W/P link 1]
(*Note)
Station number, where the send area
address for the PC link is overlapped with
this station, is stored here.
A N/A
DT9171 DT90171
Test result in the optical transmission path
test mode for MEWNET-P link system is
stored here.
DT9172 DT90172
Counts how many times a token is lost.
DT9173 DT90173
Counts how many times two or more tokens
are detected.
DT9174 DT90174
Counts how many times a signal is lost.
DT9175 DT90175
Counts how many times a synchronous
abnormality is detected.
DT9176 DT90176
Send NACK
DT9177
DT90177
Send NACK
DT9178 DT90178
Send WACK
DT9179
DT90179
Send WACK
DT9180 DT90180
Send answer
DT9181
DT90181
Send answer
DT9182 DT90182
Unidentified command
DT9183 DT90183
Counts how many times a parity error is
detected.
DT9184 DT90184
End code receiving error
DT9185
DT90185
Format error
DT9186 DT90186
Not support error
DT9187
DT90187
Self-diagnostic result
DT9188 DT90188
Counts how many times loop change is
detected.
Available PLC: FP3, FP10SH
DT9189 DT90189
Counts home many times link error is
detected.
DT9190 DT90190
Counts how many times main loop break is
detected.
Available PLC: FP3, FP10SH
DT9191 DT90191
Counts how many times sub loop break is
detected.
Available PLC: FP3, FP10SH
DT9192 DT90192
Loop reconstruction condition
Available PLC: FP3, FP10SH
DT9193 DT90193
Loop operation mode
Available PLC: FP3, FP10SH
DT9194 DT90194
Loop input status
Available PLC: FP3, FP10SH
Note) For MEWNET-W system, available PLC type: FP2/FP2SH/FP3/FP10SH
For MEWNET-P system, available PLC type: FP3/FP10SH

Panasonic fp2/fp2sh Specifications

General

Brand	Panasonic
Model	fp2/fp2sh
Category	Controller
Language	English