Panasonic FP7

Errors and Warnings
15-8
Error
code
Error name Description Object Recovered Countermeasures
3035H
Positioning
movement
amount error
The positioning movement
amount has exceeded the upper
or lower limit.
Each
axis
Yes Check the set value.
3040H
Synchronous
operation
group error
The synchronous group is
changed while the positioning
unit is in synchronous operation
or a stop request is being made.
The settings of axis groups are
outside the range.
An error has occurred during a
home return while the positioning
unit is in synchronous operation.
Each
axis
Yes
Changing the synchronous
group should be performed
when the busy signal for the
axes to be synchronized is
OFF.
It should be performed when
various stop request signals
(system stop, emergency stop,
deceleration stop) are OFF.
3042H
Synchronous
operation
home return
error
The home return process was
executed with setting the
synchronous operation to
“Enabled” when using
synchronous mode A.
A method other than the usable
home return methods was
executed when using
synchronous mode B.
Each
axis
Yes
Set the simultaneous operation
to “Disabled” while the
positioning unit is in
synchronous mode A.
Select a usable home return
method while the positioning
unit is in synchronous mode B.
3043H
Synchronous
operation
error
The operation has stopped as an
error occurred on another axis
while the positioning unit is in
synchronous operation.
Each
axis
Yes
Check the unit setting of the
stopped axis.
If an error occurs repeatedly
with the correct set values,
consult your Panasonic
representative.
3044H
Synchronous
operation not
settable
(In pulser
operation）
The setting of the synchronous
operation was changed while the
positioning unit is in pulser
operation.
Each
axis
Yes
Changing the setting of the
synchronous operation should
be performed when the pulser
operation enabled signal is
OFF.
3045H
Synchronous
axis difference
check error
The difference between the
movement amounts of the target
axes under synchronous control
exceeded the specified
difference.
Each
axis
Yes
Check the operation of the
target axes for the synchronous
operation.
3046H
Automatic
movement
amount check
error
The automatic movement amount
check function has detected that
the difference between the
instruction value and feedback
value is in excess of the preset
automatic movement amount.
Each
axis
Yes
Check the operation of the
target axes.
Check the parameters of the
automatic check function of
movement amount.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com