Unit Allocation and
Parameter Settings
5-14
5.5.3 Operation Patterns and Tables
• Use a number of tables if the positioning patterns consist of pass point control, continuance
point control, and JOG positioning control.
• In these types of control, the tables will be created continuously on the Configurator PM7,
and select the end point control for the operation pattern for the last table.
• Specify the first data table number for each control in the program.
(Example) Pass point control
Create three positioning data tables, and select “E: End point” for the last table. Furthermore,
start the first table number for each control in the user program.
REFERENCE
For detailed information on each control, refer to Chapter 7. Automatic Operation
(Positioning Control)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
