9 Anesthetic Gas Module Repairing the Anesthetic Gas Module
264
Performance
Barometric
Pressure Check
Perform Barometric Pressure Check . Difference between actual
measured pressure value and
actual ambient pressure value =
x (<= 5 mmHg)
PBP:P/x or
PBP:F/x
where P=Pass and
F=Fail
Performance Span
Calibration Check
Perform the Span Calibration Check.
Document the actual measured values for
each gas channel.
If failed (out of specified tolerances) -
perform a span calibration for specific gas
channel.
O2 value = x1 (+- 1.0% to O2
calibration value )
CO2 value = x2 (+- 0.1% to
CO2 calibration value)
N2O value = x3 (+- 2.0% to
N2O calibration value))
Agent value = x4 (+- 0.1% to
Agent value)
When calibration of EACH gas
channel was necessary, status of
each channel shows "Done".
Result to report in this case is
PSH:P (without individual gas
value results)
PSH:P/x1/x2/x3/
x4 or
PSH:F/x1/x2/x3/
x4
where P=Pass and
F=Fail
alternatively
PSH:P or
PSH:F
where P=Pass and
F=Fail
Performance
Normal Operation
Check
Enter Monitoring mode and check that all
AGM related waves and numerics are present
and correspond to the user’s configuration.
Are all AGM waves and numerics present
according to the user’s configuration?
Expected answer is "yes". If so,
performance normal operation
check is passed.
PNO: P or
PNO: F
where P=Pass and
F=Fail
Performance Pump
Te s t
Using the pump test kit provided in the PM
kit, clean and test the pump according to the
included instructions. Did the pump pass the
test?
Expected answer is "yes".
If so, test is passed.
PPU: P or
PPU: F
where P=Pass and
F=Fail
Performance Fan
Check
Check that the cooling fan runs smoothly.
Did the fan pass the test?
Expected answer is "yes".
If so, fan check is passed.
PFA: P or
PFA: F
where P=Pass and
F=Fail
Test Bloc k Na m e Test or Inspection to be performed Expected Test Result What to Record
on Service
Record
To Next Page
Loading...