Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 20/20e Defibrillator/Monitor Preventive Maintenance
Cleaning (continued)
SpO2 Cleaning
Procedure
To clean the SpO2 sensor, disconnect it from the patient cable and clean the
LNOP DCI by wiping it with a 70% isopropyl alcohol pad. Allow the sensor to dry
before placing back in use.
Clean the patient cable by wiping it with a 70% isopropyl alcohol pad and
allowing it to dry. Do not soak or immerse the cable in any liquid solution. Do not
attempt to sterilize.
7-5
To Next Page
Loading...
